first_layer_adhesion
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| first_layer_adhesion [2025/09/19 19:17] – dshoop | first_layer_adhesion [2025/10/04 01:00] (current) – dshoop | ||
|---|---|---|---|
| Line 18: | Line 18: | ||
| Level the bed with the [[SCREWS_TILT_CALCULATE]] | Level the bed with the [[SCREWS_TILT_CALCULATE]] | ||
| + | |||
| + | ==== First layer speeds too fast ==== | ||
| + | |||
| + | Try slowing down to 30mm/ | ||
| + | |||
| + | First layer speeds depend on filament material and other factors. Speeds for first layers tend to be under 60mm/s and as slow as 20mm/s for some filaments. | ||
| + | |||
| + | ==== More ==== | ||
| + | |||
| + | |||
| + | See [[tips_better_first_layers|Tips for better first layers]] for additional techniques | ||
| + | |||
| + | |||
| + | |||
| ===== Discusion: ===== | ===== Discusion: ===== | ||
/app/data/attic/first_layer_adhesion.1758323867.txt.gz · Last modified: by dshoop