first_layer_adhesion
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| first_layer_adhesion [2025/09/19 19:54] – dshoop | first_layer_adhesion [2025/10/04 01:00] (current) – dshoop | ||
|---|---|---|---|
| Line 24: | Line 24: | ||
| First layer speeds depend on filament material and other factors. Speeds for first layers tend to be under 60mm/s and as slow as 20mm/s for some filaments. | First layer speeds depend on filament material and other factors. Speeds for first layers tend to be under 60mm/s and as slow as 20mm/s for some filaments. | ||
| + | |||
| + | ==== More ==== | ||
| + | |||
| + | |||
| + | See [[tips_better_first_layers|Tips for better first layers]] for additional techniques | ||
| + | |||
| + | |||
| + | |||
| ===== Discusion: ===== | ===== Discusion: ===== | ||
/app/data/attic/first_layer_adhesion.1758326068.txt.gz · Last modified: by dshoop