Differences

This shows you the differences between two versions of the page.

--- first_time_setup [2025/10/04 01:07] – dshoop
+++ first_time_setup [2025/10/16 23:06] (current) – dshoop
@@ Line 1: / Line 1: @@
 ====== Setting Up Your Neptune 4 Printer For The First Time ======
+... or if you'd like to walk back through the process
 {{tag>articles}}
@@ Line 16: / Line 17: @@
   - [[run_a_full_bed_mesh|Run a full bed mesh]]
   - [[inspect_bed_mesh|Inspect the bed mesh for gross warpage]]
-  - Assure the filament rolls freely from the spool, without causing too much tension on the extruder
+  - Assure the filament rolls freely from the spool, without causing too much tension on the extruder.
+  - Assure the cable to the print head and bed doesn't have excess slack and has free range of motion. Use the included zip ties to attach at key positions to route the head cable. Make sure the plate doesn't hit anything behind it or in front for its full range of motion. You may need to [[cant_move_head_or_plate_motors_on|stop motors]] to move the bed or head.
   - [[how_should_i_set_the_z_offset_to_adjust_nozzle_height|Adjust Nozzle Height - Z Offset]]
-    - paper method
+    - paper method (not recommended, guaranteed to be off but in ballpark)
     - baby step calibrated
-  * A word about [[START_PRINT macro]]
+  * A word about [[print_start_workflows|Print Start Workflows]]
+  * A word about [[print_start_macro]]
   * A word about [[silicone_spacers|silicon spacers]]
@@ Line 28: / Line 31: @@
 Printing the presliced Buddha that Elegoo distributes is a good test as its known good gcode for the Neptune 4 that's been calibrated for Elegoo's PLA Filament.
+== Why not the benchy? ==
+[[The Benchy]] isn't as more a stress test than a functionality test as it has several know highly problematic features.
 === Calibrate a profile for your filament ===