Differences

This shows you the differences between two versions of the page.

--- first_time_setup [2025/10/16 23:03] – dshoop
+++ first_time_setup [2025/10/16 23:06] (current) – dshoop
@@ Line 1: / Line 1: @@
 ====== Setting Up Your Neptune 4 Printer For The First Time ======
+... or if you'd like to walk back through the process
 {{tag>articles}}
@@ Line 19: / Line 20: @@
   - Assure the cable to the print head and bed doesn't have excess slack and has free range of motion. Use the included zip ties to attach at key positions to route the head cable. Make sure the plate doesn't hit anything behind it or in front for its full range of motion. You may need to [[cant_move_head_or_plate_motors_on|stop motors]] to move the bed or head.
   - [[how_should_i_set_the_z_offset_to_adjust_nozzle_height|Adjust Nozzle Height - Z Offset]]
-    - paper method
+    - paper method (not recommended, guaranteed to be off but in ballpark)
     - baby step calibrated