Differences

This shows you the differences between two versions of the page.

--- gcode [2025/10/07 05:42] – dshoop
+++ gcode [2025/10/07 13:00] (current) – dshoop
@@ Line 2: / Line 2: @@
 {{tag> wip about}}
-...work in progress...
-{{ :shopping.png?250 |}}
+{{:shopping.png?64|}}
+...work in progress...
 See https://www.klipper3d.org/G-Codes.html for the complete set of [[Klipper]] gcode commands.
@@ Line 34: / Line 34: @@
   * Set extrude factor override percentage: M221 S<percent>
   * Set acceleration: M204 S<value> OR M204 P<value> T<value>
-  * Note: If S is not specified and both P and T are specified, then the acceleration is set to the minimum of P and T. If only one of P or T is specified, the command has no effect.
+    * Note: If S is not specified and both P and T are specified, then the acceleration is set to the minimum of P and T. If only one of P or T is specified, the command has no effect.
   * Get extruder temperature: M105
   * Set extruder temperature: M104 [T<index>] [S<temperature>]
   * Set extruder temperature and wait: M109 [T<index>] S<temperature>
-  * Note: M109 always waits for temperature to settle at requested value
+    * Note: M109 always waits for temperature to settle at requested value
   * Set bed temperature: M140 [S<temperature>]
   * Set bed temperature and wait: M190 S<temperature>
@@ Line 48: / Line 48: @@
   * Get firmware version: M115
-Klipper then further implements a set of "extended gcode", a full list of which is available [[https://www.klipper3d.org/G-Codes.html#additional-commands|here] as part of the Klipper documentation.
+Klipper then further implements a set of "extended gcode", a full list of which is available [[https://www.klipper3d.org/G-Codes.html#additional-commands|here]] as part of the Klipper documentation.
 Common Klipper extended gcode commands include:
@@ Line 63: / Line 63: @@
   * SDCARD_PRINT_FILE
   * ... and many more
-They take meaningfully named parameters which can appear in any order (as opposed to Marlin gcodes that aren't follow strict parameter order and
+They take meaningfully named parameters which can appear in any order, as opposed to Marlin gcodes that  follow strict parameter order and are referenced with preface letters like P, S, T for parameters, second, or tool specifiers which are less human-readable.
-Gcode itself is case insensitive, except for characters in comments.
+Gcode itself is case insensitive, except for characters in comments. Comments begin with a semi-colon and end at the end of the line.
+<code>
+G28 ; HOME the nozzle
+SET_HEATER_TEMPERATURE HEATER=extruder TARGET=160 ; set the extruder temperature to 160C
+</code>