Differences

This shows you the differences between two versions of the page.

--- gcode [2025/10/07 05:44] – dshoop
+++ gcode [2025/10/07 13:00] (current) – dshoop
@@ Line 2: / Line 2: @@
 {{tag> wip about}}
-...work in progress...
-{{ :shopping.png?250 |}}
+{{:shopping.png?64|}}
+...work in progress...
 See https://www.klipper3d.org/G-Codes.html for the complete set of [[Klipper]] gcode commands.
@@ Line 48: / Line 48: @@
   * Get firmware version: M115
-Klipper then further implements a set of "extended gcode", a full list of which is available [[https://www.klipper3d.org/G-Codes.html#additional-commands|here] as part of the Klipper documentation.
+Klipper then further implements a set of "extended gcode", a full list of which is available [[https://www.klipper3d.org/G-Codes.html#additional-commands|here]] as part of the Klipper documentation.
 Common Klipper extended gcode commands include:
@@ Line 63: / Line 63: @@
   * SDCARD_PRINT_FILE
   * ... and many more
-They take meaningfully named parameters which can appear in any order (as opposed to Marlin gcodes that aren't follow strict parameter order and
+They take meaningfully named parameters which can appear in any order, as opposed to Marlin gcodes that  follow strict parameter order and are referenced with preface letters like P, S, T for parameters, second, or tool specifiers which are less human-readable.
-Gcode itself is case insensitive, except for characters in comments.
+Gcode itself is case insensitive, except for characters in comments. Comments begin with a semi-colon and end at the end of the line.
+<code>
+G28 ; HOME the nozzle
+SET_HEATER_TEMPERATURE HEATER=extruder TARGET=160 ; set the extruder temperature to 160C
+</code>