Differences

This shows you the differences between two versions of the page.

--- part_knocks_shifts [2025/09/19 19:08] – dshoop
+++ part_knocks_shifts [2025/10/23 14:32] (current) – ↷ Links adapted because of a move operation dshoop
@@ Line 1: / Line 1: @@
-====== What causes parts to be knocked off or shit on the plate? ======
+====== What causes parts to be knocked off or shift on the bed plate? ======
 {{tag> faq articles}}
@@ Line 8: / Line 8: @@
 Infill patterns that cross already drawn infill lines (e.g. grid) are inconsistent with high print velocities. Use patterns like Cross Hatch, Gyroid or Honeycomb instead. Patterns like Cross Hatch offer a good balance of strength and speed along with requiring less infill density (%) than other patterns to achieve the same coverage.
-==== Misaligned Gantry ====
+==== Flow Rates Too High ====
-see [[aligning the gantry]]
-==== Flow Ratio Too High ====
+  * [[tune_extruder_rotational_distance|Tune Extruder Rotational Distance]]
+  * Tune flow ratio (see [[orca_calibrations|Orca Calibration]])
-  * Tune Extruder Rotational Distance
+  * Tune Pressure Advance (see [[orca_calibrations|Orca Calibration]])
-  * Tune flow ratio
-  * Tune Pressure Advance
 ==== Bad gcode Z Offset ====
-Properly set [[z-offset]]
+Properly set [[z_offset]]
+==== Misaligned Gantry ====
+see [[aligning the gantry]]
 ==== Other Tips ====
-  * Retract between layers and enable z hop on retraction
   * Avoid crossing perimeters
+  * Retract between layers and enable z hop on retraction