part_knocks_shifts
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| part_knocks_shifts [2025/09/19 19:08] – dshoop | part_knocks_shifts [2025/10/23 14:32] (current) – ↷ Links adapted because of a move operation dshoop | ||
|---|---|---|---|
| Line 8: | Line 8: | ||
| Infill patterns that cross already drawn infill lines (e.g. grid) are inconsistent with high print velocities. Use patterns like Cross Hatch, Gyroid or Honeycomb instead. Patterns like Cross Hatch offer a good balance of strength and speed along with requiring less infill density (%) than other patterns to achieve the same coverage. | Infill patterns that cross already drawn infill lines (e.g. grid) are inconsistent with high print velocities. Use patterns like Cross Hatch, Gyroid or Honeycomb instead. Patterns like Cross Hatch offer a good balance of strength and speed along with requiring less infill density (%) than other patterns to achieve the same coverage. | ||
| - | ==== Misaligned Gantry | + | ==== Flow Rates Too High ==== |
| - | see [[aligning the gantry]] | + | |
| - | ==== Flow Ratio Too High ==== | + | |
| - | + | * Tune flow ratio (see [[orca_calibrations|Orca Calibration]]) | |
| - | | + | * Tune Pressure Advance |
| - | * Tune flow ratio | + | |
| - | * Tune Pressure Advance | + | |
| ==== Bad gcode Z Offset ==== | ==== Bad gcode Z Offset ==== | ||
| - | Properly set [[z-offset]] | + | Properly set [[z_offset]] |
| + | |||
| + | ==== Misaligned Gantry ==== | ||
| + | see [[aligning the gantry]] | ||
| ==== Other Tips ==== | ==== Other Tips ==== | ||
| - | * Retract between layers and enable z hop on retraction | ||
| * Avoid crossing perimeters | * Avoid crossing perimeters | ||
| + | * Retract between layers and enable z hop on retraction | ||
| + | |||
/app/data/attic/part_knocks_shifts.1758323311.txt.gz · Last modified: by dshoop