part_knocks_shifts
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| part_knocks_shifts [2025/10/06 13:00] – [Flow Rates Too High] dshoop | part_knocks_shifts [2025/10/23 14:32] (current) – ↷ Links adapted because of a move operation dshoop | ||
|---|---|---|---|
| Line 11: | Line 11: | ||
| * [[tune_extruder_rotational_distance|Tune Extruder Rotational Distance]] | * [[tune_extruder_rotational_distance|Tune Extruder Rotational Distance]] | ||
| - | * Tune flow ratio (see [[calibration|Orca Calibration]]) | + | * Tune flow ratio (see [[orca_calibrations|Orca Calibration]]) |
| - | * Tune Pressure Advance (see [[calibration|Orca Calibration]]) | + | * Tune Pressure Advance (see [[orca_calibrations|Orca Calibration]]) |
| ==== Bad gcode Z Offset ==== | ==== Bad gcode Z Offset ==== | ||
| - | Properly set [[z-offset]] | + | Properly set [[z_offset]] |
| ==== Misaligned Gantry ==== | ==== Misaligned Gantry ==== | ||
/app/data/attic/part_knocks_shifts.1759770050.txt.gz · Last modified: by dshoop