Differences

This shows you the differences between two versions of the page.

--- print_start_macro [2025/10/07 05:57] – dshoop
+++ print_start_macro [2025/10/07 13:04] (current) – dshoop
@@ Line 1: / Line 1: @@
 ====== PRINT_START Macro ======
-{{tag>about, tip}}
+{{tag>about, wip}}
-{{ :shopping.png |}}
-|| ...work in progress... ||
+{{:shopping.png?64|}}
+...work in progress...
 **NOTE:** //In initial versions of [[Klipper]] that shipped as part of Elegoo's firmware distributions the PRINT_START macro was called automatically as part of the start of a new print. A latter version of Klipper changed this behavior. This meant that owners who relied on that behavior often experienced issues like the bed mesh not loading or other expected operations part of the start of printing not occurring.//
+==== Resources ====
 https://www.klipper3d.org/Slicers.html?h=start_print#start_print-macros