Differences

This shows you the differences between two versions of the page.

--- screws_tilt_calculate [2025/09/29 01:23] – dshoop
+++ screws_tilt_calculate [2025/09/29 14:22] (current) – dshoop
@@ Line 1: / Line 1: @@
 ====== SCREWS_TILT_CALCULATE ======
 {{tag>about}}
+IMPORTANT: You MUST always execute a G28 before using this command.
 ''SCREWS_TILT_CALCULATE [DIRECTION=CW|CCW] [MAX_DEVIATION=<value>] [HORIZONTAL_MOVE_Z=<value>] [<probe_parameter>=<value>]''
@@ Line 6: / Line 8: @@
 Invokes the Klipper native bed screws adjustment tool. It will command the nozzle to different locations (as defined by the [SCREWS_TILT_ADJUST] stanza in [[printer.cfg]]) probing the z height and calculate the number of knob turns to adjust the bed level.
-When SCREWS_TILT_CALCULATE is used with the MAX_DEVIATION parameter it can be used to test ahead of printing that the bed is level to within the specified maximum deviation. The command will raise a gcode error if any difference in the screw height relative to the base screw height is greater than the value provided.
+When SCREWS_TILT_CALCULATE is used with the MAX_DEVIATION parameter it can be used to test ahead of printing that the bed is level to within the specified maximum deviation. Consider using SCREWS_TILT_CALCULATE with MAX_DEVIATION as part of your printer power up macro, PRINT_START macro in printer, cfg,  or slicer machine print start gcode to validate the bed is still level within the given deviation prior to printing. If the bed screws deviate by more than MAX_DEVIATION then Klipper will halt with a warning, telling you how much to adjust each bed screw,  and allow you to re-run SCREWS_TILT_CALCULATE to properly level the bed.
+Example:
+<code>
+G28
+SCREWS_TILT_CALCULATE MAX_DEVIATION=0.02
+</code>
-IMPORTANT: You MUST always do a G28 before using this command.
 ==== [SCREWS TILT ADJUST] ====
@@ Line 32: / Line 38: @@
 </code>
-See the [[Klipper]] docs for more.
 === Other Resources ===
+See the [[Klipper]] docs for more.
 PrintsLeo3D:Let Klipper level your bed with the built-in tool screws_tilt_adjust\\
-https://www.youtube.com/watch?v=APAbl5PGEh0
+https://www.youtube.com/watch?v=APAbl5PGEh0\\
+Not the best, not well suited for the N4 series, dated.