Differences

This shows you the differences between two versions of the page.

--- tips_better_first_layers [2025/10/04 00:13] – dshoop
+++ tips_better_first_layers [2025/10/08 14:22] (current) – ↷ Links adapted because of a move operation dshoop
@@ Line 6: / Line 6: @@
 To understand what makes for good first layers we need to understand [[https://manual.slic3r.org/advanced/flow-math|Flow Math]] and the relation that layer height and extrusion width have to the surface area presented by the extruded filament against the build plate (or layer beneath, for layers after the first.)
-==== Tips ====
+===== Tips =====
 === Make sure the bed is level ===
@@ Line 14: / Line 14: @@
 From the Slic3r docs: "Having a level bed is critical. If the distance between the nozzle tip and the bed deviates by even a small amount it can result in either the material not lying down on the bed (because the nozzle is too close and scrapes the bed instead), or the material lying too high from the bed and not adhering correctly."
-=== How to tell if the bed is level ===
+== How to tell if the bed is level ==
 To tell if the bed is level execute the following gcode in the [[Fluidd]] [[console]]:
@@ Line 23: / Line 23: @@
 </code>
-You can also include the same gcode in the [[slicer]]'s machine print start gcode or Klipper's [[PRINT_START]] macro. If the bed isn't level the print will stop.
+You can also include the same gcode in the [[slicer]]'s machine print start gcode or Klipper's [[print_start_macro]]. If the bed isn't level the print will stop.
 ==== Properly set z offset ====