Normally this is caused by a combination of the following issues:

Infill patterns that cross already drawn infill lines (e.g. grid) are inconsistent with high print velocities. Use patterns like Cross Hatch, Gyroid or Honeycomb instead. Patterns like Cross Hatch offer a good balance of strength and speed along with requiring less infill density (%) than other patterns to achieve the same coverage.

• Tune Extruder Rotational Distance
• Tune flow ratio (see Orca Calibration)
• Tune Pressure Advance (see Orca Calibration)

Properly set z-offset

see aligning the gantry

• Avoid crossing perimeters
• Retract between layers and enable z hop on retraction